Message Boards Message Boards

Set several parameters on a FEM Method for NDEIgensistem?

Posted 6 years ago

Hello everyone…I'm here again to ask for help... last time you helped me and for this I thank you... using the finite element method (FEM)... I need some tips..

  • I have to set “omega” which should be the seventh eigenvalue calculated with NDEIgensistem but I can not set it...

  • I should set the “theta” corner which is the angle of entry of the sea into the port and should have a value included by ??<?/2 measured in radians

I attach the notebook where I tried several attempts Trusting in your help, I thank you

Attachments:
POSTED BY: BARBU DENISIA
Reply to this discussion
Community posts can be styled and formatted using the Markdown syntax.
Reply Preview
Attachments
Remove
or Discard

Group Abstract Group Abstract