Change the markers of a 3D mesh?

Questions
1

Is it possible to change the number of 3D face markers? I would like to put a different number on each face. Attached is a notebook.
Regards,
Sinval

Open in Wolfram Cloud ↗
2

In the documentation for ToBoundaryMesh I see an option called "BoundaryMarkerFunction". Did you try it?

3

Thank you for your attention Gianluca. I found the “BoundaryMarkerFunction” option in the documentation, but I couldn’t adapt it to the mesh created in the attached document. I will keep searching.

4

Sinval Santos,

since your mesh visualization

meshgraphics = 
  bmesh["Wireframe"[PlotRange -> {All, All, {0, 10}}, 
    "MeshElementMarkerStyle" -> Directive[FaceForm[Red]], 
    "MeshElementStyle" -> Directive[FaceForm[Opacity[0.5, Green]]]]];

is just a Graphics3D, a simple hack is possible:

i = 1;
Replace[meshgraphics, Text[_, p__] :> Text[i++, p], All]

meshindx.png
meshindx.png464×342 19.9 KB

5

Hello Henrik, thanks for your attention.
This procedure replaces all markers. I’m creating a routine to replace just a few specific markers.