Meaning of three vertical dots between factors in a Notebook line of output

The symbol is in fact that produced by the escape key. Ilian Gachevski spotted the symbol in In[50], where I must have hit the excape key by mistake. I would never have noticed that. Thanks, Illian. The symbol is carried through subsequent calculations as a factor, just as it appears at In[50]. Is it safe just to erase this symbol where it appears, or should I redo all the calculations after removing the symbol at In[50]? I think the latter procedure may be the safest. Now I will go to the web manual to find out what “escape” means and where it is used. Thanks to everyone for your interest and for solving the problem. Who knew about the escape key?

One way you might have found this yourself would have been to copy the symbol from where you first noticed it in the output and then searched for that symbol starting from the top of the notebook to see where it first appeared.

If the Mathematica session in which these computaitons were done is still active then you can remove the symbol from In[50] and execute the remainder of the notebook from there. If however you’ve quit Mathematica then you need to do the full computation starting from the beginning.