Group Abstract Group Abstract

Message Boards Message Boards

0
|
5.2K Views
|
6 Replies
|
0 Total Likes
View groups...
Share
Share this post:

How to get image into Wolfram engine

peter clarke
Posted 5 years ago
POSTED BY: peter clarke
6 Replies
Sort By:
peter clarke
peter clarke
Posted 5 years ago

Thanks Ahmed. I will try that
POSTED BY: peter clarke
peter clarke
peter clarke
Posted 5 years ago
POSTED BY: peter clarke

I am not sure if Canon's software is causing the problem? my suggestions is to remove any software that may use the camera, then make sure that its driver is updated.
POSTED BY: Ahmed Elbanna

It may be a driver issue. EasyCamera had some driver issues at its early versions for Windows 10. I also remember having this issue with my Lenovo laptop, and it was fixed after couple of software updates.
POSTED BY: Ahmed Elbanna
Rohit Namjoshi
Rohit Namjoshi
Posted 5 years ago

The list of available devices

$ImagingDevices

The current device

 $ImagingDevice

If the only device you have is EasyCamera and it is the current device then most likely the reason for failure is what is reported in the error message

Check that the camera is properly connected and that it is not currently in use by another application
POSTED BY: Rohit Namjoshi
peter clarke
peter clarke
Posted 5 years ago

EasyCamera is not a device but a piece of software to use with a camera that you may have. I have a Canon. So apparently I would have to somehow bypass the Canon software to use the EasyCamera software.Then this would be the only way to get an image into the Wolfram engine for processing. Refer to the other answer on this subject.
POSTED BY: peter clarke
Reply to this discussion
Community posts can be styled and formatted using the Markdown syntax.
Tag limit exceeded
Note: Only the first five people you tag will receive an email notification; the other tagged names will appear as links to their profiles.
Reply Preview
Attachments
Remove
or Discard