Message Boards Message Boards

0
|
10929 Views
|
3 Replies
|
1 Total Likes
View groups...
Share
Share this post:

Is SystemModeler Compatible with OpenModelica Power Systems Library?

Posted 10 years ago

After loading OpenModelica PowerSystems Library, an attempt to simulate any of the included examples results in an error:

" Connector .PowerSystems.Generic.Ports.Terminal_n is not balanced: The number of potential variables (3) is not equal to the number of flow variables (2)"

Can this be fixed by the user, or require new SystemModeler release? Thanks, G

POSTED BY: gibz WOL
3 Replies

WSM 12.2 appears to be compatible with OpenIPSL 2.0 Beta! They are still working on the examples, so there may be errors in the code which are fixable. OpenIPSL allows dynamic analysis of the power system and even has a new distribution hybrid that will allow single phase distribution analysis with the transmission-level analysis.

POSTED BY: Glen K. Halley

Hi,

According to the Modelica specification 3.2rev2, section 9.3.1: For each non-partial connector class the number of flow variables shall be equal to the number of variables that are neither parameter, constant, input, output, stream nor flow. Basically saying that the number of flow variables should be equal to the number of potential variables. this might cause the problem in the library.

We will take a look at this and verify whether it's a library problem or due to something that is not supported in WSM yet. you.

POSTED BY: Jan Brugard
Posted 10 years ago

Hi,

It doesn't seem like this can be fixed easily by the user and would require some improvements to SystemModeler.

POSTED BY: Updating Name
Reply to this discussion
Community posts can be styled and formatted using the Markdown syntax.
Reply Preview
Attachments
Remove
or Discard

Group Abstract Group Abstract