Thanks for the suggestions. I have taken a look at the code, and it offers some ideas.

I am in the process of rewriting some ancient (ca 1972) BASIC code, and my first inclination is to imitate the BASIC paradigm as much as is needed to do a port. I could have done a lin-by-line translation -- Mathematica has a GOTO construct, after all -- but my aim is to master tbhe Mathematica way. What I will end up with is not going to be a one-to-one transformation, but I wil (finally) master the Mathematica way.

I already use the paradigm of returning a new list, and I have learned not to worry about what goes on under the hood. What I need to do is to adjust the logic so that the code does not depend on side effects from executing a function. Tricky, in the case of ancient BASIC, but do-able.

I begin to understand the contention that BASIC ruins people for real programming. At the time, however, it was BASIC or FORTRAN (c had not been invented), and my primary job was a research biochemist, so FORTRAN was a bit more than I needed for the type of computatins I needed to do.

Fortunately, I do not have to worry about fitting everythng into 8K of address space.

Thanks. I'll check it out. My real function has several parameters, and has a return value. I'm assuming that HoldFirst will work if I only want to pass the first parameter by reference.

It strikes me, though, that this construct is not good Mathematica practice.

For many purposes the use of HoldXXX attributes is perfectly sensible. If you really need to do this in a way that emulates pointers,  might get some ideas from

http://stackoverflow.com/questions/6691491/implementing-a-quadtree-in-mathematica

Thanks for all your help. I have some sample code:

This is a toy example of what I want to do. There are separate functions. One does the UI part, using a slider to set a percentage. There is a function that uses the current values of entE1 and entS1 to cumpute new values of the variables using the percentage eEn.  The display code in setEnergy[] is there for debugging purposes.

This code works as written.

I tried to have setEnergy[] return the new values of entE1 and entS1, but if I did so, they were not dynamically updated. I tried wrapping Dynamic around the returned variables, to no avail. (I thought that this approach would work.)

I tried some other variations without much success.

As I said, this version works, and I can apply it to my real code. I would like to know if there is a more elegant solution.

Thanks.